seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Brake calliper AP Racing (16??)): Removing and installing. > < Removal:

Leon Mk2

Installation
Installation
Installation is carried out in the reverse sequence; note the following:
  Note
Do not damage the protective covers of the pistons when you fit the brake pads.
–  Carefully fit the brake pads.
   
–  Fit the pad securing spring and insert the securing pins in the direction of the -arrow A- on to the brake calliper. When doing this, press the pad support spring -arrow B- down a little until the notch of the support pin protrudes over the edge of the spring.
  E46-0049
–  Fit security fasteners -arrows-.
–  Install the retaining screw of the brake saddle and tighten to a tightening torque → Item.
–  Fit the wheels → Wheels and tyres; Rep. gr. 44.
  WARNING
After fitting the brake pads, operate the brake pedal strongly with the vehicle stopped so that the brake pads adopt the position corresponding to normal operation.
–  Check the brake fluid level and refill in case of doubt.
  A46-0136

Brake calliper AP Racing (16??)): Removing and installing. > < Removal: