Leon Mk2
| Hand brake lever - general overview |
| 1 - | Hand brake lever |
| q | Prior to removal, remove the extension of the centre console → Body, interior installation work; Rep. Gr.68 . |
| 2 - | Trim |
| q | Removing: press the locking tab of the rear lower part using a small screwdriver, and remove it by pulling forward |
| 3 - | Expansion tab |
| 4 - | Re-adjusting bolt |
| q | Adjusting handbrake |
| vehicles with drum brakes → Chapter |
| vehicles with disc brakes → Chapter |
| 5 - | Collar |
| q | Removing |
| – | Remove the handbrake cable from the guide tube. |
| – | Remove the socket. |
| – | Separate the socket from the guide tube. |
| q | Installation: |
| Make sure that the socket is correctly seated in the bodywork. |
| 6 - | Right guide tube |
| q | For hand brake cable |
| 7 - | Left guide tube |
| q | For hand brake cable |
| 8 - | Hand brake cable |
| q | removing and fitting → Chapter. |
| 9 - | Handbrake lever securing point |
| q | Soldered in the bodywork tunnel |
| 10 - | Handbrake warning switch -F9- |
| 11 - | Bolt |
| q | 20 Nm + 90° |
| q | Replace after each removal |