Leon Mk2
|
| 1 - | Protective cap |
| 2 - | Air drain plug, 10 Nm |
| q | Before tightening, apply a fine layer of assembly paste to the screw thread → Parts catalogue |
| 3 - | Cover caps |
| q | Insert into sleeve bearing. |
| 4 - | Guide pin, 30 Nm |
| 5 - | Sleeve bearing |
| q | Fit into the brake calliper housing |
| 6 - | Housing for brake calliper |
| 7 - | Brake carrier |
| q | Tighten with the brake calliper housing |
| 8 - | Retaining spring |
| q | Hook into the two holes in the brake calliper housing |
| 9 - | Sealing ring |
| q | Take care not to damage when inserting piston. |
| q | Removing and installing → Chapter |
| 10 - | Piston |
| q | Removing and installing → Chapter |
| q | Apply a thin coating of assembly paste to the piston → Parts catalogue |
| 11 - | Protective cap |
| q | Pull on so that outer sealing lip goes over piston. |
| q | Take care not to damage when inserting piston. |
| q | Removing and installing → Chapter |
