Leon Mk2
Electrical/electronic components and fitting locations |
1 - | ABS hydraulic unit -N55- |
The hydraulic unit consists of the components: |
q | Hydraulic pump -V64-, checked by self-diagnosis. |
q | Valve block (contains the in/outlet valves). |
q | The hydraulic pump -V64- and valve block must not be separated from one another → Chapter |
q | When changing the hydraulic unit always seal the old part with the plugs from the repair set -1H0 698 311 A- |
2 - | ABS control unit -J104- |
q | Checked by self-diagnosis |
q | Located on the hydraulic unit on left of engine compartment. |
q | Checking the multi-pin connector to control unit → VAS 5051 |
q | Do not disconnect connector before successfully completing interrogation of fault memory. First switch ignition off then separate connector. |
3 - | ABS/EDL hydraulic unit -N55- |
The hydraulic unit consists of the components: |
q | Hydraulic pump -V64-, checked by self-diagnosis. |
q | Valve block (contains the in/outlet valves). |
q | The hydraulic pump -V64- and valve block must not be separated from one another → Chapter |
q | When changing the hydraulic unit, always seal the old part with the plugs from the repair set -1H0 698 311 A- |
4 - | ABS/EDL control unit -J104- |
q | Checked by self-diagnosis |
q | Located on the hydraulic unit on left of engine compartment. |
q | Checking the multi-pin connector to control unit → VAS 5051 |
q | Do not disconnect connector before successfully completing interrogation of fault memory. First switch ignition off then separate connector. |
5 - | Brake light switch -F- |
q | The brake light switch is open in the rest position. |
q | Adjusting → Chapter |
q | Can be checked via read measured value block → VAS 5051 |
6 - | Brake system warning lamp -K118- |
q | Location: In the dash panel insert |
Function: → Chapter |
7 - | ABS warning lamp -K47- |
Locations: |
q | Location: in dash panel insert |
Function: → Chapter |
8 - | Handbrake warning lamp -K14- |
q | Location: In the dash panel insert |
Function: → Chapter |
9 - | Impulse wheel for rear right and left speed sensors |
q | Removing and installing → Chapter |
10 - | Impulse wheel for front right and left speed sensors |
q | Removing and installing → Chapter |
11 - | Front right/left speed sensor (-G45-/-G47-) |
q | Checked by self-diagnosis |
q | Before inserting the sensor clean the inner surface of the sensor mounting and coat with lubricating paste -G 000 650- |
q | When connecting the speed sensor wire ensure it is not twisted in the wheel housing |
q | Securing bolt tightening torque - 10 Nm |
12 - | Rear right/left speed sensor (-G44-/-G46-) |
q | Installation instructions → Item |
13 - | Diagnostic connections |
q | Location: Behind driver's side stowage compartment |