SEAT Workshop Service and Repair Manuals > Leon Mk2 > Running gear | Running gear, axles, steering - front and four-wheel drive | Steering | Vane pump, reservoir, hydraulic pipes

Tensioning V-belt

Special tools and workshop equipment required

t	Torque wrench -V.A.G 1410-

t	Ring spanner insert -V.A.G 1410/2-

–	Loosen hexagon nut -4- → Note.

–	Loosen hexagon bolts -1- → Note.

–	Loosen clamp -3- on clamping bolt -8- (⇒ Fig. V48-1064 → Anchor) by at least one turn → Note.

–	Tension V-belt by turning the clamping bolt -8-(⇒ Fig. V48-1064 → Anchor) with torque wrench-A- (-V.A.G 1410- and -V.A.G 1410/2-).

Specification: used belts, 4 Nm new belts, 7 Nm

–	Tighten clamp -3- on clamping bolt → Chapter.

–	Tighten hexagon bolt -1- → Chapter.

–	Tighten hexagon bolt -2- and nut -4- → Chapter.

Note

Nut -4- is only installed on petrol engines.

¹⁾	If not already loosened.

SEAT Workshop Service and Repair Manuals