skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing a side airbag crash sensor > < Removing and installing restoring ring with slip ring

Fabia Mk1

Removing and installing passenger airbag unit
Removing and installing passenger airbag unit
Special tools and workshop equipment required
t  Loctite -275- (commercially available)
  WARNING
Safety regulations should be observed when handling the airbag units → Chapter.
Additional operations should be carried out after the battery earth strap has been disconnected and connected → Electrical System; Rep. Gr.27.
Removing
–  Disconnect earth strap of the battery.
   
–  Remove the glove compartment → Chapter.
–  Disconnect the airbag unit plug connector.
–  Unscrew bolts -2-.
–  Take airbag unit -1- out of the dash panel.
Install
  Note
secure using a securing screw -Loctite 275-.
–  Fit airbag unit onto holder in the dash panel.
–  Mount the airbag unit connector.
–  Install the glove compartment → Chapter.
–  Switch on ignition.
–  Connect earth cable of the battery.
  WARNING
Nobody should be in the vehicle when the battery is being connected.
  S69-0100
Tightening torque
ComponentTightening torques
Airbag unit of front passenger side to dash panel holder10 Nm

   

Removing and installing a side airbag crash sensor > < Removing and installing restoring ring with slip ring