Fabia Mk1
II - Summary of components of suspension strut |
Note
The wheel-bearing housing for disc brake FS-III is showen on the figure. Different versions of the wheel-bearing housing do not influence the installation of the suspension strut. |
1 - | Wheel-bearing housing |
2 - | Nut, 60 Nm + 90° |
q | replace after each removal |
3 - | Screw |
q | replace after each removal |
4 - | Shock absorber |
q | removing and installing → Chapter |
q | can be replaced individually |
q | must be replaced completely |
q | check → Chapter |
q | disposing of → Chapter |
q | Assignment → Electronic Catalogue of Original Parts |
5 - | Stop buffer |
6 - | Boot |
7 - | Coil spring |
q | check colour coding |
q | The surface of the spring coil must not be damaged |
q | replace axle-wise |
q | the coil springs on the axle must be of the same manufacturer |
q | removing and installing → Chapter |
q | Assignment → Electronic Catalogue of Original Parts |
8 - | Axial grooved ball bearing |
9 - | Suspension strut bearing |
10 - | Self-locking nut, 60 Nm |
q | replace after each removal |
11 - | Suspension strut dome |
12 - | 15 Nm + 90° |
q | replace after each removal |
q | when installing the suspension strut, first mount the screws on the inside of the vehicle |
13 - | Cap |
q | clipped into the suspension strut |