Fabia Mk1
Summary of components of pressure line (hose) - power steering TRW or KOYO - LHD version |
In the figure, the hose is illustrated at an engine pump aggregate of the TRW. The hose is identical for the engine pump aggregate of KOYO |
1 - | Engine pump aggregate |
q | with noise encapsulation, assignment → Electronic Catalogue of Original Parts |
q | with half noise encapsulation, assignment → Electronic Catalogue of Original Parts |
q | without noise encapsulation, assignment → Electronic Catalogue of Original Parts |
2 - | Return line (return hose) |
q | Assignment → Electronic Catalogue of Original Parts |
q | must not be pinched off during disassembling work |
q | No less than minimum bending radius of 100 mm |
q | removing and installing → Chapter |
3 - | Line holder |
4 - | Power-steering gear |
5 - | Pressure line (expansion hose) |
q | Assignment → Electronic Catalogue of Original Parts |
q | must not be pinched off during disassembling work |
q | No less than minimum bending radius of 100 mm |
q | Pay attention to installation position relative to subframe → Anchor |
q | removing and installing → Chapter |
6 - | Spacer holder |
q | clipped onto body |
7 - | Cable of power-assisted steering sensor -G250- |
q | power-assisted steering gear - engine pump aggregate |
|
Tightening torques: |
Pressure line to the power-assisted steering gear (TRW)
| 35 Nm | ||
Pressure line to the power-assisted steering gear (KOYO) | 40 Nm |