skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Installing: > < Removing and installing the hydraulic lines TRW - RHD version

Fabia Mk1

Removing:
Removing:
–  Use catch pan to collect the drained off hydraulic oil.
   
–  Unscrew the screwed lid -1- for the hydraulic oil reservoir -2- of the engine pump aggregate.
–  Extract the hydraulic oil with an extraction bottle via the filler neck.
–  Remove wheels at the front.
–  Remove the front left wheelhouse liner → Body Work; Rep. gr.66.
  S48-0147
–  Unclip return line -4- from the line holders -5-.
–  Open spacer holder -7-.
–  Take return-flow line -4- or pressure line -6- out of the spacer -7-.
–  Open the spring strap clamp -2- with assembly pliers and carefully pull off the return line from the support of the engine pump aggregate -1-.
–  Unscrew pipe screw -3- from the engine pump aggragate and pull out the pressure line.
8 - Cable of power-assisted steering sensor -G250-
–  Close the threaded bores and supports on the engine pump aggregate.
–  Remove the screws attaching the assembly carrier to the body in the prescribed sequence and replace them with the fixing bolts from -T10096- → Chapter.
  Caution
When lowering the assembly carrier make sure the line of the power-steering sensor -G250- is not exposed to traction, if necessary separate the plug on the engine pump aggregate.
–  Lowering assembly carrier with power-assisted steering gear.
  S48-0199
–  Disconnect pressure line -1- or return-flow line -2- from steering gear.
3 - for power-assisted steering sensor - G250- with fixed connecting line (TRW):
4 - Assembly carrier
5 - Fixing bolt from -T10096-
–  Seal threaded holes on the steering gear (e.g. with plastic screw plugs).
  S48-0351
–  Raise power-assisted steering gear, remove clip -1- and thus slacken pressure line and return line.
–  Remove pressure or return line.
  S48-0353

Installing: > < Removing and installing the hydraulic lines TRW - RHD version