Removing and installing engine pump aggregate KOYO |
Special tools and workshop equipment required |
t
| Vehicle system tester -V.A.G 1552- or vehicle diagnosis, measurement and information system -VAS 5051- |
t
| Removal and installation pliers, e.g. -VAS 5024- |
t
| Jumper cable (commercially available) |
t
| Catch pan (commercially available) |
t
| Extraction bottle (commercially available) |
In the event of failure determine the cause with the functional, pressure and tightness test as well as by performing self-diagnosis. |
Note t
| Do not use drained hydraulic oil again. |
t
| After extraction there will be residual hydraulic oil in the engine pump aggregate as well as in the hydraulic lines. |
t
| Do not pinch off the hydraulic lines with hose clamps -MP7-602 (3094)- or any other tools. Pinching off may result in damage to the pressure and return line. |
t
| To avoid damage make sure the bending radius of at least 100 mm is respected when bending or tying up the pressure line. |
|
|
|