| Installing engine pump aggregate: |
Note | t
| Only use original spring band clamps. |
| t
| Install spring strap clamp with assembly pliers, e.g. -VAS 5024-. |
| t
| Do not use drained hydraulic oil again. |
| t
| After installing the engine pump aggregate fill with hydraulic oil → Chapter. |
| t
| When installing the pressure line on the engine pump aggregate use new O-ring. |
| Installation is carried out in the reverse order. Pay attention to the following: |
| –
| It is absolutely necessary to counterhold the rubber bearings when tightening the nuts to secure the holder on the engine pump aggregate. |
Caution | Observe the applicable safety instructions for disconnecting the battery with jumper cables! |
|
| –
| If necessary connect removed battery to jumper cables. |
| –
| If necessary install air filter. |
| –
| Filling with hydraulic oil and bleeding the steering system → Chapter |
| –
| If necessary disconnect the jumper cable. |
| –
| If necessary re-install the air filter. |
Note | If faults are stored in the fault memory: |
|
|
|
