skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Inspecting the exhaust system for leaktightness > < Replacing the middle and rear part of the exhaust system

Fabia Mk1

Aligning exhaust system free of stress
Aligning exhaust system free of stress
Work procedure
l  The exhaust system is aligned when cold.
   
–  Slacken bolted connections on the double clamp between pre-exhaust pipe with catalytic converter and middle and rear part of exhaust system.
–  Position double clamp at the distance -a- = 5 mm from the marking on the pre-exhaust pipe with catalytic converter and tighten front bolted connection slightly (bolts at bottom and horizontal).
  S26-0064
–  Push middle part of exhaust system -1- sufficiently far forward into the double clamp until the dimension -b- of 3 to 7 mm is achieved between hanger - body and hanger - middle part of exhaust system.
   The -arrow- shows the direction of travel.
–  Tighten bolted connections on the double clamp in this position.
   Tightening torque: 25 Nm
  Note
After tightening, check dimension -b- and adjust if necessary.
  S26-0065

Inspecting the exhaust system for leaktightness > < Replacing the middle and rear part of the exhaust system