Fabia Mk1
Summary of components of exhaust pipe |
1 - | Gasket |
q | replace |
2 - | Gasket |
q | replace |
q | Fitting position: notch faces down |
3 - | 25 Nm |
q | coat with hot screw paste G 052 112 A3 before inserting |
4 - | Exhaust manifold |
q | to remove take off intake manifold → Chapter |
5 - | 20 Nm |
q | replace |
6 - | Hot air collector/heat shield |
7 - | Guide tube |
q | for the oil dipstick |
8 - | Retaining strap |
q | Pay attention to the part number |
q | to remove the pre-exhaust pipe with catalytic converter, press off from the bracket → Item |
9 - | Clamp |
10 - | 25 Nm |
11 - | Double clamp |
q | align exhaust system free of stress before fitting on → Chapter |
q | Fitting position: bolts at bottom and horizontal |
q | Tighten bolted connections evenly |
12 - | Lambda probe downstream of catalytic converter -G130 -, 50 Nm |
q | with 4 connections on engines complying with EU3, EU3 DDK, D4 and EU4 exhaust emission standard |
q | the thread of new lambda probes must be coated with assembly paste |
q | for a re-used lambda probe, only coat the thread with hot bolt paste -G 052 112 A3- |
q | the hot bolt paste -G 052 112 A3- must not come into contact with the slots of the probe body |
q | use lambda probe wrench for removing and installing |
13 - | 25 Nm |
q | replace |
14 - | Retaining strap |
q | Pay attention to the part number |
15 - | Retaining strap |
q | Pay attention to the part number |
16 - | Separation point |
q | for repairs → Chapter |
q | marked at the pipe with an indentation |
17 - | Retaining strap |
q | Pay attention to the part number |
18 - | Middle and rear part of the exhaust system |
q | for first equipment a building unit |
q | Replace individually when carrying out repairs → Chapter |
q | Align exhaust system free of stress → Chapter |
19 - | Exhaust pipe with catalytic converter |
q | on engines complying with EU3, EU3 DDK, D4 and EU4 exhaust emission standard |
q | with two lambda probes |
20 - | Lambda probe -G39-, 50 Nm |
q | with 4 connections on engines complying with EU2 exhaust emission standard, on others with 6 connections |
q | the thread of new lambda probes must be coated with assembly paste |
q | for a re-used lambda probe, only coat the thread with hot bolt paste -G 052 112 A3- |
q | the hot bolt paste -G 052 112 A3- must not come into contact with the slots of the probe body |
q | use lambda probe wrench for removing and installing |
21 - | Exhaust pipe with catalytic converter |
q | on engines complying with EU2 exhaust-emission standard |
q | with one lambda probe |
22 - | 40 Nm |
q | replace |
q | Coat stud bolts with hot bolt paste -G 052 112 A3 - before installing |