Fabia Mk1
| Removing and installing sealing flange and flywheel |
Note| t | Repairs to the clutch → gearbox; Rep. Gr.30. |
| t | For carrying out assembly work, attach the engine with the engine mount -MP 1-202- and sleeves -T30010- to the assembly stand. |
| 1 - | Sealing ring |
| q | made of PTFE |
| q | replace → Chapter |
| q | only install PTFE gasket ring (pay attention to different versions → Fig.) |
| 2 - | Sealing flange on the belt pulley side |
| q | must be positioned on dowel sleeves |
| q | removing and installing → Chapter |
| 3 - | Cylinder block |
| q | removing and installing crankshaft → Chapter |
| q | Disassembling and assembling pistons and conrods → Chapter |
| 4 - | The two-mass flywheel |
| q | removing and installing → Chapter |
| q | Assembly only possible in one position - holes offset |
| 5 - | 60 Nm + torque a further 90° (1/4 turn) |
| q | replace |
| 6 - | Intermediate plate |
| q | must be positioned on dowel sleeves |
| q | do not damage/bend during assembly work |
| q | hang on the sealing flange → Fig. |
| 7 - | 15 Nm |
| 8 - | Sealing flange on the gearbox side |
| q | with PTFE gasket ring |
| q | to remove and install, take off oil pan → Chapter |
| q | must be replaced completely |
| q | only install sealing flange with PTFE gasket ring (pay attention to different versions → Fig.) |
| q | install gasket ring dry, the crankshaft stub must be free of grease |
| q | install new sealing flange with sleeve (do not pull guide sleeve off the gasket ring before installing) |
|
|
| I | Elastomer gasket ring sealing lip -1-; with garter spring |
| II | PTFE gasket ring multiple sealing lips -2-; without garter spring |
Note
|
|
|
