skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Fuel supply, gas operation > < Removing and installing coolant pump

Fabia Mk1

Removing and installing coolant regulator
Removing and installing coolant regulator
Special tools and workshop equipment required
t  Catch pan (e.g. - V.A.G 1306 -)
t  Torque wrench 5 through 50 Nm
t  Pliers for spring strap clips
Removing
  Note
Always replace seals and gasket rings.
   
–  Remove engine cover → Chapter.
–  Drain coolant → Chapter.
  S10-0144
–  Remove coolant hose from connection fittings -2-.
–  Release the fixing screws -1- of the connection fittings and remove connection fittings -2- with coolant regulator -4-.
–  Turn coolant thermostat -4-1/4 turn (90°) to the left and separate plug connection -2-.
Installing
Installation is carried out in the reverse order. Pay attention to the following:
–  Clean sealing surface for O-ring.
  N19-0232
–  Moisten new O-ring -3- with coolant and insert on connection fitting -2-.
–  Fit coolant regulator -4- in the connection fitting -2- and turn 1/4 turn. (90°) to the right.
  Note
The coolant regulator clamps must be virtually vertical.
–  Insert the connection fitting -2- with coolant regulator -4- in the cylinder block.
–  Tighten fixing screws -1-.
   Tightening torque: 15 Nm
–  Filling system with coolant → Chapter.
  N19-0232

Fuel supply, gas operation > < Removing and installing coolant pump