skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Valve Seats/Valves Guide/Valve Stem Seal > < Removing and installing camshaft

Fabia Mk1

Removing and installing gasket ring for camshaft
Removing and installing gasket ring for camshaft
Special tools and workshop equipment required
t  Inserting device - MP 1-214-
t  Gasket ring extractor -T30003-
t  Torque wrench
t  Screw -M12x65-
Removing
–  Removing timing belt → Chapter.
–  Remove camshaft sprocket and hub → Chapter.
–  Turn inner part of gasket ring extractor -T30003- two turns (approx. 3 mm) out of the outer part and lock with knurled screw.
   
–  Oil the thread head of the gasket ring extractor, position and forcefully screw into the gasket ring as far as possible.
–  Slacken knurled screw and turn inner part of seal extractor against the camshaft until the seal is pulled out.
Installing
  Note
The sealing lips of the PTFE gasket ring must neither be oiled nor greased.
–  Remove oil residue on the camshaft stud with a clean cloth.
–  Cover the slot on the camshaft cone with commercially available adhesive tape (e.g. with sellotape).
–  Carefully fit seal onto camshaft.
  S15-0169
–  Press in the gasket ring with inserting device -MP 1-214- and screw -M12x65- up to the stop.
–  Install and tension timing belt → Chapter.
  S15-0170

Valve Seats/Valves Guide/Valve Stem Seal > < Removing and installing camshaft