skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Disassembling and assembling the differential > < Removing

Fabia Mk1

Installing
Installing
For gearbox up to 06.00
   
–  Drive the new seal ring in up to the stop, do not twist the seal ring.
–  Fill the space between the sealing lips and dust lips with sealing grease -G 052 128 A1-.
  S39-0074
–  Secure the flange shaft in a vice fitted with protective jaws. Push out the old circlip from the flange shaft groove with the new circlip -A-.
–  Drive in the flange shaft with a plastic hammer.
For gearbox after 06.00
  V34-2005
–  Drive the new seal ring in up to the stop, do not twist the seal ring.
–  Fill the space between the sealing lips and dust lips with sealing grease -G 052 128 A1-.
–  Secure the flange shaft with the conical screw.
For all gearboxes
–  Screw the right drive shaft to the flange shaft.
–  Install the wheelhouse liner in the wheelhouse.
–  Check gear oil level, if necessary pour in up to lower edge of filler hole → Chapter.
–  If available install the noise insulation.
Tightening torques
  S39-0145
ComponentsTorque
Flange shaft on gearbox (conical screw)25 Nm
Tighten drive shaft to flange shaft M8 crosswise in 2 steps (I and II) → NoteI - 10 Nm
II - 40 Nm
Steering joint to track control arm → Note M820 Nm + 90°
Wheel bolts to wheel hub120 Nm

1)  Always replace these bolts
   

Disassembling and assembling the differential > < Removing