Skoda Workshop Service and Repair Manuals

Setting the shift mechanism Special tools and workshop equipment required t  Rig pin -T10027 A-   Note t  The following are required for correct setting of the shift mechanism: t  Operating and transmission elements of the shift mechanism are in perfect condition. t  Shift mechanism operates freely. t  Gearbox, clutch and clutch control in perfect condition. l  Gearbox in Neutral.

–  Pull forward the locking mechanism at shift cable and at selector cable as far as the stop -arrow 1-, then lock by turning to the left -arrow 2-. Fix the gearshift shaft as follows:

–  Press the gearshift shaft down -arrow 1-. –  When pressing down the gearshift shaft, press the angle lever -A- slightly towards the gearshift shaft and then turn the angle lever in -the direction of arrow 2-

–  Lever the collar out of the surround of centre console -arrows-. –  Guide shift lever in Neutral to the left into the 1st/2nd gear gate.

–  Insert rig pin -T10027 A - through hole -A- into hole -B-.

–  Now turn the locking mechanism at the shift cable and at the selector cable to the right as far as the stop -direction of arrow 1-. The spring pushes the locking mechanism into the initial position -arrow2-.

–  Now turn the angle lever -A- back to the initial position -direction of arrow-.

–  Pull rig pin - T10027 A- out of hole -A- and -B-. –  Fit collar into the surround for centre console.