–
| Tighten the new fixing screws of the cylinder head cover crosswise and evenly from the inside to the outside. Tightening torque 10 Nm + torque a further 1/4 turn (90°). |
WARNING The camshaft housing must not tilt! |
|
Note t
| After installing the cylinder head cover, allow the sealant to dry for about 30 minutes. |
t
| Do not rework the sealing surface of the cylinder head cover. |
t
| After installing new hydraulic balancing elements, the engine must not be started for about 30 minutes. The hydraulic balancing elements must „settle“ (otherwise the valves would strike the pistons). |
The further assembly is carried out in reverse order to disassembly. |
|
|
|