skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Fuel supply, gas operation > < Removing and installing coolant pump

Fabia Mk1

Removing and installing coolant regulator
Removing and installing coolant regulator
Special tools and workshop equipment required
t  Catch pan, e.g. -V.A.G 1306- or -VAS 6208-
t  Pliers for spring strap clamps
Removing
  Note
Always replace seals and gasket rings.
   
–  Remove engine cover.
   To do so pull the front and rear engine cover upwards with a sudden motion -arrows-.
–  Drain coolant → Chapter.
  S10-0115
–  Remove coolant hose from connection fittings -2-.
–  Unscrew bolts -1- attaching connection and remove connections -2- together with coolant thermostat -4-.
–  Turn coolant thermostat -4- 90° (1/4 turn) to the left and separate from connection fitting -2-.
Install
Installation is carried out in the reverse order. Pay attention to the following:
–  Clean sealing surface for O-ring.
  A19-0027
–  Moisten new O-ring -3- with coolant and fit onto connection fitting -2-.
–  Fit coolant regulator -4- in the connection fitting -2- and turn 90° (1/4 turn) to the right.
  Note
Coolant thermostat arms must be virtually vertical.
–  Insert the connection fitting -2- with coolant regulator -4- in the cylinder block.
–  Tighten fixing screws -1-.
   Tightening torque: 15 Nm
–  Top up coolant → Chapter.
  A19-0027

Fuel supply, gas operation > < Removing and installing coolant pump