Fabia Mk1
Cylinder head - summary of components |
Removing and installing → Chapter. |
Testing compression pressure → Chapter. |
Note
t | When installing a replacement cylinder head with fitted crankshaft moisten the contact surfaces between the bucket tappets and the cam slide with engine oil. |
t | Do not remove the plastic bases supplied as a protection for the open valves until just before fitting on the cylinder head. |
t | After replacing the cylinder head, the system must be completely filled with fresh coolant. |
t | It is not permissible to rework the cylinder head of diesel engines. |
1 - | Cylinder head gasket |
q | replace |
q | Pay attention to the marking → Fig. |
2 - | 20 Nm |
3 - | Cylinder head |
q | check for distortion → Fig. |
q | removing and installing → Chapter |
q | after replacing fill entire system with fresh coolant → Chapter |
4 - | Lifting eye |
5 - | Ball knob screw, 8 Nm |
q | for attaching the engine cover |
6 - | Cylinder head bolt |
q | replace |
q | pay attention to sequence for loosening and tightening → Chapter |
7 - | Oil deflector |
8 - | Cylinder head cover |
q | with vulcanized gasket |
q | if the seal has been damaged replace cylinder head cover |
9 - | Collar |
q | replace if damaged |
10 - | Screw cap |
q | Replace seal if damaged |
11 - | Ventilation tube |
q | To intake manifold |
12 - | Retaining clip |
13 - | Pressure control valve |
q | for crankcase ventilation |
14 - | Gasket |
q | replace if damaged |
15 - | 10 Nm |
16 - | Injection lines |
q | tighten: 25 Nm |
q | remove with open ring spanner |
q | replace as a set only |
q | do not change bending form |
17 - | Support |
18 - | 20 Nm |
19 - | Vacuum pump |
q | for brake servo unit |
20 - | 20 Nm |
21 - | Gasket |
q | replace |
Note
|