skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Oil filter - Summary of components > < Removing and installing parts of the lubrication system
Summary of components
   
Summary of components
  Note
t  If considerable quantities of metal swarf or abrasion is found in the engine oil when carrying out engine repairs, carefully clean the oil galleries in order to avoid consequential damage and additionally replace the engine oil cooler.
t  Testing oil pressure and oil pressure switch → Chapter.
t  The engine oil level must not exceed the „max“ marking - risk of damage to catalytic converter!
Check the oil level, oil capacity, oil specification → BookletFabia.
1 - Oil pump
q   with pressure relief valve 1.2 MPa (12 bar)
q   Before installing, check whether both dowel sleeves for centering oil pump/cylinder block are present
q   If there is any scoring on contact surfaces and gears, replace
2 - Oil pump sprocket
q   pay attention to correct installation position
q   Fits onto oil pump shaft in one position only
3 - 25 Nm
4 - Oil pump chain
5 - Sealing flange
q   on belt pulley side
q   insert with sealant → Electronic Catalogue of Original Parts
q   removing and installing → Chapter
q   Replace crankshaft seal on belt pulley side → Chapter
6 - 15 Nm
7 - Chain tensioner, 15 Nm
q   When installing, pretension spring and attach
8 - Sprocket
9 - Dipstick
q   the oil level must not be above the „max“ marking!
q   Inspecting engine oil level → BookletFabia
10 - Hopper
q   Remove for extracting oil
11 - Guide tube
12 - Oil injection nozzle
q   for cooling pistons
13 - Pressure valve, 27 Nm
q   opens at a pressure of 0.25 ... 0.32 MPa (2.5 ... 3.2 bar)
q   install without sealant
14 - O-ring
q   replace
15 - Suction line
q   Clean strainer if dirty
16 - Baffle
17 - Oil pan
q   insert with sealant → Electronic Catalogue of Original Parts
q   removing and installing → Chapter
18 - Drain plug, 30 Nm
q   with gasket
q   replace
19 - 10 Nm
20 - Oil level and oil temperature sender -G266-
q   check → Vehicle diagnostic tester
21 - O-ring
q   replace

   

Oil filter - Summary of components > < Removing and installing parts of the lubrication system