Fabia Mk1
| For engines with identification characters AWY, BMD |
| 1 - | Cylinder head with cover |
| q | check for distortion → Fig. |
| q | removing and installing → Chapter |
| q | after replacing fill entire system with fresh coolant |
| q | Repairing valve gear → Chapter, → Chapter |
| 2 - | Bellows |
| q | for engine with identification characters AWY |
| 3 - | Gasket |
| q | replace if damaged |
| 4 - | Screw cap |
| 5 - | 20 Nm |
| 6 - | Left lifting eye |
| 7 - | Cylinder head bolt |
| q | replace |
| q | observe the mounting instructions and sequence for loosening and tightening → Chapter |
| 8 - | from connecting hose |
| q | for engine with identification characters BMD |
| 9 - | Ventilation hose with non-return valve |
| q | for engine with identification characters BMD |
| 10 - | from air filter |
| q | for engine with identification characters AWY |
| 11 - | Bleeder hose |
| q | for engine with identification characters AWY |
| 12 - | Camshaft position sensor -G163- |
| 13 - | 8 Nm |
| 14 - | Sealing ring |
| q | replace if damaged |
| 15 - | Support |
| q | for wiring loom |
| 16 - | Oil pressure switch -F1-, 25 Nm |
| q | 0.045 MPa (0.45 bar) |
| q | check → Chapter |
| 17 - | Sealing ring |
| q | replace |
| 18 - | Cylinder head gasket |
| q | replace |
| q | Observe fitting position: Part number must be legible |
| 19 - | Bolt, 18 Nm |
| q | for tensioning rail or possibly also guide rail |
| 20 - | 20 Nm + torque a further 90° (1/4 turn) |
| q | replace |
| 21 - | Camshaft sprocket |
| q | removing and installing → Chapter |
| 22 - | Right lifting eye |
