skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Engine cylinder head, valve gear > < Replacing crankshaft seal on belt pulley side

Fabia Mk1

Replacing the gasket ring for the crankshaft on the flywheel side
Replacing the gasket ring for the crankshaft on the flywheel side
Special tools and workshop equipment required
t  Assembly device -T10122-
l  Gearbox removed
Removing
–  Remove flywheel → Chapter (Pos. 8).
   
–  Remove the gasket ring carefully using a screwdriver -A-.
  Note
The adhesive surface must not get damaged when removing the gasket ring.
Install
  Note
The sealing lips of the gasket ring must be neither oiled nor greased.
  S13-0320
–  Push the assembly device -T10122/1- into the assembly device -T10122/2- and gasket ring -A-, then push onto the assembly device -T10122/2-, as shown.
–  Remove assembly device -T10122/1-.
–  Remove oil residue on the crankshaft journal with a clean cloth.
  S13-0356
–  Insert the gasket ring with assembly device -T10122/2-.
–  Drive in gasket ring with assembly device -T10122/3- up to the stop.
Further installation occurs in reverse order.
  S13-0357

Engine cylinder head, valve gear > < Replacing crankshaft seal on belt pulley side