skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Replace middle and rear silencer > < Middle and rear silencer - Summary of components

Fabia Mk1

Aligning exhaust system free of stress
Aligning exhaust system free of stress
l  The exhaust system is aligned when cold.
–  Slacken bolted connections on the clamping sleeve between front and middle silencer and replace nuts.
   
–  Position clamping sleeve at the distance -a- = 5 mm from the marking on the pre-exhaust pipe (bolts at bottom and horizontal) and tighten front bolted connection slightly.
  S26-0064
–  Push middle silencer -1- sufficiently far forward into the clamping sleeve until the dimension -b- of 3 to 7 mm is achieved between hanger/body and hanger/middle silencer.
   The -arrow- shows the direction of travel.
–  Tighten bolted connections on the clamping sleeve in this position.
   Tightening torque: 23 Nm
  Note
After tightening, check dimension -b- and adjust if necessary.
  S26-0065

Replace middle and rear silencer > < Middle and rear silencer - Summary of components