Fabia Mk1
| For engines with identification characters BMD, BME ▶ 11.05 |
| 1 - | Heat shield |
| 2 - | 8 Nm |
| 3 - | Exhaust manifold with integrated catalytic converter |
| q | Pay attention to the part number |
| q | Inspecting catalyst → Vehicle diagnostic tester |
| 4 - | Lambda probe -G39-, 50 Nm |
| q | Pay attention to the part number |
| q | in front of the catalytic converter |
| q | coat only thread with hot bolt paste -G 052 112 A3-; hot bolt paste must not get into the slot of the probe body |
| q | Testing lambda probe -G39- and lambda control upstream of catalytic converter → Vehicle diagnostic tester |
| 5 - | Gasket |
| q | replace |
| 6 - | Heat shield - short |
| q | for vehicles without air conditioning |
| 7 - | Heat shield - extended |
| q | for vehicles with an air conditioning system |
| 8 - | 22 Nm |
| 9 - | 23 Nm |
| 10 - | Pre-exhaust pipe |
| q | for engines with identification characters BMD complying with exhaust emission standard EU-4 |
| q | for engines with identification characters BME complying with exhaust emission standard EU-4 and EU-2 DDK |
| 11 - | Clamping sleeve |
| q | align exhaust system free of stress before fitting on → Chapter |
| q | Fitting position: bolts at bottom and horizontal |
| q | Tighten screwed connections uniformly |
| 12 - | Pre-exhaust pipe |
| q | for engines with identification characters BMD complying with exhaust emission standard EU-2 DDK |
| 13 - | Retaining strap |
| q | replace if damaged |
| 14 - | 20 Nm |
| 15 - | Strut |
| 16 - | 40 Nm |
| q | replace |
| q | coat stud bolts of exhaust manifold with hot bolt paste -G 052 112 A3- before installing. |
| 17 - | Lambda probe downstream of catalytic converter -G130-, 50 Nm |
| q | coat only thread with hot bolt paste -G 052 112 A3-; hot bolt paste must not get into the slot of the probe body |
| q | Testing lambda probe -G130- and lambda control downstream of catalytic converter → Vehicle diagnostic tester |
| 18 - | Gasket |
| q | replace |
| 19 - | 25 Nm |
| q | replace |
| q | coat stud bolts of exhaust manifold with hot bolt paste -G 052 112 A3- before installing. |
| 20 - | Heat shield |
| q | for engines with identification characters BME |
| q | for nordic countries |
