skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

For engines with identification characters AZQ, BME > < For engine with identification characters AWY
For engine with identification characters BMD
   
For engine with identification characters BMD
1 - 8 Nm
2 - Throttle valve control unit -J338-
q   check → Vehicle diagnostic tester
q   when replacing the engine control unit perform adaptation → Vehicle diagnostic tester
q   6-pin plug
3 - O-ring
q   pay attention to correct installation position
q   replace
4 - from activated charcoal filter system solenoid valve 1 -N80-
5 - from vacuum regulating valve (PCV valve)
6 - Intermediate piece
7 - Sealing ring
q   replace
8 - 20 Nm
9 - 2 Nm
10 - Intake manifold pressure sender -G71- with intake air temperature sender -G42-
q   4-pin plug
q   contacts gold-plated
11 - O-ring
q   replace if damaged
12 - Retaining clip
13 - Intake manifold
14 - Intake manifold
q   with integrated intermediate piece

   

For engines with identification characters AZQ, BME > < For engine with identification characters AWY