Fabia Mk1
| Lubrication system - Summary of components |
| 1 - | Oil pump |
| q | with safety valve 1.2 MPa (12 bar) |
| q | before installing, check whether both dowel sleeves for centering the oil pump/cylinder block are mounted |
| q | if there is any scoring on contact surfaces and gears, replace |
| q | Tightening torque of screws for pump cover 10 Nm |
| 2 - | Oil pump sprocket |
| q | Check fitting position |
| q | Fits onto oil pump shaft in one position only |
| 3 - | 25 Nm |
| 4 - | Oil pump chain |
| q | when removing mark running direction |
| q | check for wear |
| 5 - | Sealing flange |
| q | removing and installing → Chapter |
| q | install with silicone sealant -D 176 404 A2- |
| q | replace the gasket ring for the crankshaft → Chapter |
| 6 - | 15 Nm |
| 7 - | Chain tensioner, 15 Nm |
| q | must be replaced completely, do not dismantle |
| q | Check fitting position |
| q | When installing, pretension spring and attach |
| 8 - | Crankshaft sprocket |
| 9 - | Dipstick |
| q | Oil level must not exceed the max. marking |
| q | Inspecting engine oil level → BookletFabia |
| 10 - | Filler funnel |
| q | Remove for extracting oil |
| 11 - | Guide tube |
| 12 - | Oil injection nozzle |
| q | for piston cooling |
| q | delivered together with Pos. 13 |
| 13 - | Pressure valve, 27 Nm |
| q | opens at a pressure of 0.13...0.16 MPa (1.3...1.6 bar) |
| q | delivered together with Pos. 12 |
| q | install without sealant |
| 14 - | O-ring |
| q | replace |
| 15 - | Suction line |
| q | Clean strainer if dirty |
| 16 - | Baffle |
| 17 - | Oil pan |
| q | removing and installing → Chapter |
| q | install with silicone sealant -D 176 404 A2- |
| 18 - | Drain plug, 30 Nm |
| q | with gasket |
| q | replace |
| 19 - | 10 Nm |
| 20 - | Oil level and oil temperature sender -G266- |
| q | only for vehicles with extended servicing intervals (ESI) |
| 21 - | Gasket |
| q | replace |
