–
| Disconnect the plug connection from the ignition switch. |
–
| Remove the safety varnish from the securing screw -A-. |
–
| Loosen the two securing screws -A- somewhat and pull out the ignition switch from the steering lock housing -arrow-. |
Installation is performed in the reverse order. Pay attention to the following points: |
–
| When installing the ignition/starter switch and the steering lock must be in the same position, e.g. “Ignition ON”. |
–
| After tightening the both steering lock fixing screws, secure them again with locking varnish. |
|
|
|