–
| Push piston back with piston jig -MP9-403-. |
–
| Install the heat shield. |
Fitting location: insert plate at heat shield into the opening (slot) of the brake caliper. |
–
| Install the pad retaining plate. |
–
| Fit brake caliper to the brake carrier. |
| Do this while using new collar screws from the repair set. |
–
| Attach brake line to fixture and secure with new clip. |
–
| Connect the plug connection for the brake pad wear indicator (where the vehicle is fitted with this). |
Note t
| After each brake pad replacement, forcefully apply the brake pedal repeatedly to ensure the brake pads go into their normal operating position. |
t
| Check brake fluid level after replacing the brake pads, if necessary top up with brake fluid. |
|
|
|