t
| If the drive shaft cannot be pulled out of the wheel-bearing housing, e.g. for removal use the extractor -MP6-425 (3283)- |
Note Remove possible corrosion and grease residue from the thread and from the serration of the outer joint as well as from the serration of the wheel-bearing housing. |
–
| Grease the serration on the propeller shaft with polycarbamide grease - G 052 142 A2-. |
| Do not grease thread on the outer joint of the drive shaft. |
–
| Grease the serration in the wheel-bearing housing with polycarbamide grease -G 052 142 A2 -. |
–
| Slide the outer joint into the serration of the wheel-bearing housing. |
–
| Secure the outer joint of the drive shaft with a new twelve-point nut. |
Note t
| Use new nuts to screw the track control arm/steering joint. |
t
| Make sure the steering joint boot is neither damaged nor twisted. |
|
|
|