–
| Pull out the track control arm -1- using the multi-purpose tool -MP3-419 (VW 771)- from the console. |
Note When pulling out the track control arm ensure that the wheel house trim panel and the noise insulation are not damaged. |
–
| Brush the track control arm studs with assembly sliding oil -G 294 421 A1-. |
Caution t
| When sliding in observe that the track control arm is in the correct installed position relative to the console. The surface of the track control arm must correspond with the surfaces in the console bearing → Chapter. |
t
| The track control arm should be flush with the assembly carrier. |
t
| If the fitting position is not respected, the rubber-metal bearing of the console may be damaged and its life may be shortened. |
|
–
| Insert the track control arm by hand into the rubber-metal bearing of the console, if necessary use a rubber hammer. |
|
|
|