skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Test conditions > < General points
It is necessary to perform a vehicle alignment in the event of:
It is necessary to perform a vehicle alignment in the event of:
t  there is incorrect driving behaviour
t  damage caused by accident and if parts have been replaced
t  components of the axle were removed or replaced
t  there is unilateral tyre wear
   
Removal and installation of parts carried out
Front axle - removed and installed partChassis alignment requiredRear axle - removed and installed partChassis alignment required
yesnoyesno
track control arm xShock absorber x
Wheel-bearing housing xCoil spring x
Track rod/track-rod endsx Complete rear axlex 
Steering gearx    
Assembly carrier x1)   
Suspension strut x   
Console for engine-gearbox assembly carrierx    
Anti-roll bar x1)   

1) Precondition: the assembly carrier was aligned in the service position before removal, vehicles up to CW 11 2008 → Chapter, vehicles as of CW 12 2008 → Chapter.
   
Replacement of parts carried out
Front axle - replaced partChassis alignment requiredRear axle - replaced partChassis alignment required
yesno yesno
track control arm xShock absorber x
Bearing for track control arm xCoil spring x
Wheel-bearing housingx Bearing for rear axlex 
Track rod/track-rod endsx Complete rear axlex 
Steering gearx    
Assembly carrierx    
Suspension strut  x   
Console for engine-gearbox assembly carrierx    
Anti-roll bar x1)   

1) Precondition: the assembly carrier was aligned in the service position before removal, vehicles up to CW 11 2008 → Chapter, vehicles as of CW 12 2008 → Chapter.
   

Test conditions > < General points