Skoda Workshop Service and Repair Manuals

Replacing gasket ring for crankshaft on belt pulley side (Roomster) Special tools and workshop equipment required t  Gasket ring extractor -MP1-226 (3203)- t  Assembly device -T10053- t  Bushing -T10053/1- t  Bolt (M16 x 1.5 x 60) -T10053/2- t  Counterholder -T30004 - or -MP1-310 - Removing –  Removing toothed belt → Chapter.

–  Remove crankshaft - toothed belt sprocket. To this end lock the toothed belt gear with counterholder -T30004 - or -MP1-310-.   Note When screwing on the counterholder place -MP1-310- 2 washers between the timing belt gear and the counterholder.

–  Screw the bolt by hand into the crankshaft as far as the stop. –  Unscrew inner part of the gasket ring extractor -MP1-226 (3203)- nine turns (approx. 17 mm) out of the outer part and lock with knurled screw.

–  Oil the thread head of the gasket ring extractor -MP1-226 (3203)-, position and forcely screw into the gasket ring as far as possible. –  Release knurled screw and turn the inner side against the crankshaft until the gasket ring is pulled out. Install   Note t  Only fit PTFE gasket rings. Do not fit elastomer gasket rings with a garter spring. t  The sealing lips of the PTFE gasket ring must neither be oiled nor greased. –  Remove oil residue on the crankshaft journal with a clean cloth.

–  Position bushing -T10053/1- on the crankshaft stub. –  Slide gasket ring over the bushing onto the crankshaft stub.

–  Press in the gasket ring with assembly device -T10053- and screw -T10053/2- up to the stop.

–  Install timing belt gear on the crankshaft and lock with counterholder -T30004- or -MP1-310-.   Note t  When screwing on the counterholder place -MP1-310- 2 washers between the timing belt gear and the counterholder. t  Replace central screw for crankshaft toothed belt sprocket. –  Tighten new central screw for crankshaft toothed belt sprocket to 120 Nm and turn a further 90° (1/4 turn). –  Installing the timing belt → Chapter.