skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Replacing gasket ring for crankshaft on belt pulley side (Roomster) > < Summary of components (Roomster)

Fabia Mk2

Replacing gasket ring for crankshaft on belt pulley side (Superb II)
Replacing gasket ring for crankshaft on belt pulley side (Superb II)
Special tools and workshop equipment required
t  Counterholder -T30004 (3415)- or Counterholer -MP1-310 (3099)-
t  Gasket ring extractor -MP1-226 (3203)-
t  Assembly device -T10053-
Removing
l  Engine installed.
–  Removing toothed belt → Chapter.
   
–  Remove crankshaft toothed belt sprocket, to this end lock toothed belt sprocket with counterholder or counterholder for toothed belt sprocket.
  S13-0166
–  Before positioning the gasket ring extractor, screw the central bolt of the toothed belt sprocket into the crankshaft by hand up to the stop.
–  Unscrew inner part of the gasket ring extractor -MP1-226 (3203)- two turns (approx. 3 mm) out of the outer part and lock with knurled screw.
  S13-0476
–  Oil the thread head of the gasket ring extractor, position and forcely screw into the gasket ring as far as possible.
–  Release knurled screw and turn the inner side against the crankshaft until the gasket ring is pulled out.
–  Clamp gasket ring extractor into the vice and remove gasket ring with pliers.
–  Clean the contact and sealing surfaces.
Install
  Note
Do not oil the sealing lip and the outer surface of the gasket ring before the pressing in procedure.
–  Remove oil residue on the crankshaft journal with a clean cloth.
  S13-0078
–  Install -T10053/1- guide bushing on the crankshaft stub.
–  Slide gasket ring over the guide bushing.
  S13-0454
–  Press in the gasket ring flush with the central screw for toothed belt sprocket and with pressure bushing of -T10053-.
  Note
t  There must not be any oil present on contact surface between toothed belt sprocket and crankshaft.
t  Replace central bolt for toothed belt sprocket.
t  Do no oil central screw for toothed belt sprocket.
–  Install crankshaft toothed belt sprocket, to this end lock toothed belt sprocket with counterholder or counterholder for toothed belt sprocket.
–  install (set the timing) → Chapter.
–  Install the V-ribbed belt → Chapter.
  S13-0455

Replacing gasket ring for crankshaft on belt pulley side (Roomster) > < Summary of components (Roomster)