–
| Use a flat screwdriver to press in the plastic lug -arrow- of the positioning unit for air distribution flaps -2- and pull out flex shaft -1-. |
Note t
| The flex shaft can only be installed in one way on the positioning unit and on the heater control. |
t
| When installing, however, the positioning unit and the rotary knob of the heater control must be in a certain position relatively to each other, otherwise this will result in malfunctions. |
–
| Fit flex shaft onto positioning unit of air distribution flaps and lock in place. |
–
| Use the flex shaft to move the defrost flap into vertical position („open“). |
–
| Set air distribution knob on heater control to „defrost“. |
–
| In this position, insert flex shaft into control and lock in place. |
|
|
|