skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Summary of components - Hydraulic (Fabia II ?; Roomster ?) > < Removing and installing the clutch pedal with the over-centre helper spring (Fabia II 2011 ?; Roomster 2011 ?)

Fabia Mk2

Removing and installing the clutch pedal with the tension spring (Fabia II 2011 ►; Roomster 2011 ►)
Removing and installing the clutch pedal with the tension spring (Fabia II 2011 ►; Roomster 2011 ►)
  Note
t  Install the clutch pedal with a new bearing axle.
t  If only the tension spring is removed, pay attention → Anchor.
Special tools and workshop equipment required
t  Hook -3438-
t  Pliers -T10005-
t  Allan key, wrench size 8 mm, commercially available
Removing
–  Removing the footwell vent → Heating and Air Conditioning; Rep. gr.87.
   
–  If present, release screws -arrows- and remove crash strut -A-.
–  Remove clutch pedal switch -F36- → Chapter.
  S30-0216
–  Unhook the tension spring e.g with hook -3438-.
  Note
Only observe the right part of the fig. -arrows- when installing.
  N30-10226
–  Unlock the actuating rod/master cylinder from the clutch pedal as follows:
–  Pull clutch pedal slightly into the passenger compartment.
–  Press together both sides of the support using the pliers -T10005--arrows-.
  N30-0280
–  Remove the bearing axle for the clutch pedal.
–  Turn the bearing axle for the clutch pedal to the left in -direction of arrow-.
-1- = Allan key, wrench size 8 mm.
The catches -A- are destroyed.
Then the studs -B- are positioned horizontally.
–  Subsequently move the clutch pedal so that the bearing axle can be pulled out.
–  Remove clutch pedal from bracket.
Install
l  Install the clutch pedal with a new bearing axle.
  N30-10227
–  The support -2- must be located on the actuating rod -1- of the master cylinder.
–  Insert a new bearing axle in the bracket and the clutch pedal.
  A30-0133
–  Position the studs -A- horizontally.
–  Turn the bearing axle to the right in -direction of arrow-.
-1- = Allan key, wrench size 8 mm.
l  The catches -B- must click audibly into place.
Then the studs -A- are positioned vertically.
–  Lock the clutch pedal with the support on the actuating rod of the master cylinder.
  N30-10229
–  Hook in the tension spring.
–  Insert the vibration damper with the recess -arrows- as of the 2nd spring coil -arrows-.
–  Install the clutch pedal switch -F36- → Chapter.
  N30-10226
–  If present, install crash strut -A-. To do so, tighten fixing screws -arrows- to tightening torque → Item.
–  Install the footwell vent → Heating and Air Conditioning; Rep. gr.87.
  S30-0216

Summary of components - Hydraulic (Fabia II ?; Roomster ?) > < Removing and installing the clutch pedal with the over-centre helper spring (Fabia II 2011 ?; Roomster 2011 ?)