skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the clutch pedal (Fabia II 2007 ?; Roomster 2006) > < Removing and installing the crash strut for the clutch pedal (Fabia II 2007 ?; Roomster 2006 ?)

Fabia Mk2

Removing and installing the over-centre helper spring (Fabia II 2007 ►; Roomster 2006 ►)
Removing and installing the over-centre helper spring (Fabia II 2007 ►; Roomster 2006 ►)
Special tools and workshop equipment required
t  Pliers -T10005-
t  Polycarbamide grease -G 052 142 A2-
Removing
–  Remove the storage area on the driver's side → Body Work; Rep. gr.70.
–  Remove crash strut (if present) → Chapter.
–  Remove clutch pedal switch -F36-, if present → Item.
   
Unlock the actuating rod/master cylinder from the clutch pedal as follows:
–  Pull clutch pedal slightly into the passenger compartment.
–  Insert pliers -T10005- in the clutch pedal recesses.
–  Press together both sides of the support inwards using the pliers -T10005--arrows- and separate the clutch pedal from the master cylinder.
  S30-0051
–  Press the over-centre helper spring towards the front wall -in direction of arrow- and remove it downwards.
Install
  S30-0064
l  Check whether the bearing -arrow 1- for the over-centre helper spring is inserted in the bracket.
Fitting position:
The peg of the bearing is located in the recess of the master cylinder -arrow 2-.
–  First of all, insert the over-centre helper spring in the rear bearing.
  S30-0068
–  Then press the over-centre helper spring onto the centering pin of the clutch pedal -arrow-.
–  Connect clutch pedal to master cylinder → Chapter.
–  Install the clutch pedal switch -F36- → Item.
–  Install crash strut (if present) → Chapter.
–  Install the storage area on the driver's side → Body Work; Rep. gr.70.
  S30-0065

Removing and installing the clutch pedal (Fabia II 2007 ?; Roomster 2006) > < Removing and installing the crash strut for the clutch pedal (Fabia II 2007 ?; Roomster 2006 ?)