Skoda Workshop Service and Repair Manuals

Setting shift mechanism (Fabia II, Roomster) Special tools and workshop equipment required t  Rig pin -T10027A-   Note t  The following are required for correct setting of the shift mechanism: t  Operating and transmission elements of the shift mechanism are in perfect condition. t  Shift mechanism operates freely. t  Gearbox, clutch and clutch control in perfect condition. l  Gearbox in Neutral.   Note After the battery earth strap is disconnected and connected, carry out additional operations → Electrical System; Rep. gr.27. –  Remove battery and battery tray → Electrical System; Rep. gr.27. –  Remove air filter → Engine; Rep. gr.23.

–  Pull forward the locking mechanism at shift cable and at selector cable as far as the stop in -direction of arrow 1-, then lock by turning to the left in -direction of arrow 2-.

Fix the gearshift shaft as follows: –  Press down the gearshift shaft in -direction of arrow 1-. –  When pressing down the gearshift shaft turn angle lever -A- in -direction of arrow 2- upwards and at the same time press it in carefully until it locks into the gearshift shaft.

–  Lever off the collar with disassembly wedge -3409- out of the surround of centre console in -direction of arrow-. –  Pull the collar upwards over the gearshift knob. –  Guide shift lever in Neutral position to the left into the 1st/2nd gear gate via the leg.

–  Insert rig pin -T10027A- into the hole -A- and into the hole -B-.

–  Turn locking mechanism at shift cable and at selector cable to the right up to the stop -direction of arrow-. The spring pushes the locking mechanism into the initial position.

–  Turn the angle lever -A- back to the initial position -in direction of arrow-.

–  Pull rig pin -T10027A- out of hole -A- and -B-. –  Perform a functional test of the shift mechanism → Chapter. –  Fit collar into the surround for centre console. –  Install air filter → Engine; Rep. gr.23. –  Install the battery tray and battery → Electrical System; Rep. gr.27.