skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Control measurement > < Setting drive shaft

Fabia Mk2

Determine thickness of the adjusting washer
Determine thickness of the adjusting washer
Example:
   
Measured value of bearing playThickness of the adjusting washer according to the table
1.21 mm1.175 mm

   
–  Remove drive shaft and press out outer ring/tapered-roller bearing from the gearbox housing with thrust washer -MP3-456 (VW 447 I)-.
–  Determine the adjusting washer thickness from the table → Anchor (example 1.175 mm).
Adjusting washer table
  S35-0057
Bearing clearanceAdjusting washer
Measured value (mm)Thickness (mm)
0,671 … 0,699
0,700 … 0,724
0,725 … 0,749		0,650
0,675
0,700
0,750 … 0,774
0,775 … 0,799
0,800 … 0,824		0,725
0,750
0,775
0,825 … 0,849
0,850 … 0,874
0,875 … 0,899		0,800
0,825
0,850
0,900 … 0,924
0,925 … 0,949
0,950 … 0,974		0,875
0,900
0,925
0,975 … 0,999
1,000 … 1,024
1,025 … 1,049		0,950
0,975
1,000
1,050 … 1,074
1,075 … 1,099
1,100 … 1,124		1,025
1,050
1,075
1,125 … 1,149
1,150 … 1,174
1,175 … 1,199		1,100
1,125
1,150
1,200 … 1,224
1,225 … 1,249
1,250 … 1,274		1,175
1,200
1,225
1,275 … 1,229
1,300 … 1,324
1,325 … 1,349		1,250
1,275
1,300
1,350 … 1,374
1,375 … 1,399
1,400 … 1,424		1,325
1,350
1,375
1,425 … 1,449
1,450 … 1,474
1,475 … 1,499		1,400
1,425
1,450
1,500 … 1,524
1,525 … 1,549
1,550 … 1,574		1,475
1,500
1,525
1,575 … 1,599
1,600 … 1,624
1,625 … 1,649		1,550
1,575
1,600
1,650 … 1,674
1,675 … 1,699
1,700 … 1,724		1,625
1,650
1,675

  Note
Assign the adjusting washers via the → Electronic Catalogue of Original Parts.
   
–  Press outer ring/tapered-roller bearing with thrust washer -MP3-413 (VW 510)- into the gearbox housing together with the adjusting washer (in the example 1.175 mm).
–  Position the gearbox housing and tighten screws to the given tightening torque → Chapter.
  S35-0058

Control measurement > < Setting drive shaft