skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Removing and installing shift mechanism (Fabia II, Roomster)|Install > < Removing and installing shift mechanism (Fabia II, Roomster)
Removing
Removing
  Note
If the battery earth strap is disconnected and connected, carry out additional operations → Electrical System; Rep. gr.27.
–  Remove air filter → Engine; Rep. gr.23 or → Engine; Rep. gr.24.
–  Remove battery and battery tray → Electrical System; Rep. gr.27.
   
–  Remove lock washer -3- for shift cable from gearbox shift lever -1-.
Metal relay lever
–  Remove circlip -4- for selector cable from relay lever -2-.
–  Remove selector cable and shift cable from the studs.
Plastic relay lever
–  Pull off shift cable from the stud.
–  Remove relay lever together with cable lock → Chapter.
Continued for all vehicles
  N34-1860
–  Disconnect the Bowden cable support from gearbox -arrows-.
  S34-1094
–  Lever off the collar with two disassembly wedges -3409- out of the surround of the centre console in -direction of arrow-.
–  Pull the collar upwards over the gearshift knob.
  S34-10001
–  Turn securing mechanism -arrow A- in -direction of arrow B- and pull off gearshift knob together with the collar.
–  Removing surround for the centre console → Body Work; Rep. gr.68.
  S34-1072
–  Unscrew fixing nuts -arrows- attaching the shift housing.
–  Remove pre-exhaust pipe → Engine; Rep. gr.26.
  S34-1069
–  Remove underbody cover on right and left (if present) -arrows-.
  S34-1066
–  Remove tunnel bridge -arrows-.
–  Unhook rear silencer in such a way that it does not come in contact with the rear axle.
  S34-1065
–  Remove heat shield -arrows-.
–  Swivel shift housing down and remove with control cables.
  S34-1064

Removing and installing shift mechanism (Fabia II, Roomster)|Install > < Removing and installing shift mechanism (Fabia II, Roomster)