skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing selector lever control cable (Fabia II, Roomster, Rapid) > < Removing

Fabia Mk2

Install
Install
Installation is performed in the reverse order, pay attention to the following points:
Tightening torques (the screws or nuts as well as the instructions, if the screws or nuts have to be replaced):
t  Fabia II and Roomster up to 10.11 → Chapter.
t  Rapid and vehicles Fabia II and Roomster as of 11.11 → Chapter.
–  Insert the selector lever control cable in the cable support/gearbox and carefully press onto the gearshift lever. Do not bend the gearshift lever, otherwise it will no longer be possible to adjust the gearshift operation exactly.
–  Do not bend or buckle selector lever control cable.
   
–  Hang the selector lever control cable -1- in the clip -arrow- at the gearbox. For the routing of the selector lever control cable to the ATF cooler maintain a distance of at least 5 mm.
–  Clamp the selector lever control cable on the gearbox side with the fixing part to the heat shield of the exhaust system.
–  Install exhaust system and align free of stress → Engine; Rep. gr.26.
–  Install the centre console → Body Work; Rep. gr.68.
–  Installing the cover for the shift mechanism → Chapter.
  WARNING
Observe measures when disconnecting and connecting the battery → Electrical System; Rep. gr.27.
–  Connect earth strap of battery → Electrical System; Rep. gr.27.
–  Then adjust the selector lever control cable → Chapter.
–  Inspect gearshift mechanism → Chapter.
For vehicles Rapid and vehicles Fabia II and Roomster as of 11.11
–  Check operation of the ignition key anti-removal lock → Chapter
  S37-0195

Removing and installing selector lever control cable (Fabia II, Roomster, Rapid) > < Removing