Fabia Mk2
Note
| 1 - | Cover for shift mechanism |
| q | removing and installing → Chapter |
| 2 - | Intermediate piece |
| 3 - | 25 Nm |
| q | 4 pieces |
| q | for attaching the gearshift mechanism to body |
| 4 - | Gearshift mechanism (bearing pot) |
| q | removing and installing → Chapter |
| q | with firmly integrated circuit board for gearshift mechanism, do not touch |
| q | with firmly integrated Tiptronic switch -F189-, this can be checked in the „Targeted fault finding“ → Vehicle diagnostic tester |
| q | replace gearshift mechansim if Tiptronic switch -F189- defective → Chapter |
| 5 - | Selector lever lock solenoid -N110- |
| q | removing and installing → Chapter |
| q | is checked by self-diagnosis |
| 6 - | Retaining clip |
| q | for selector lever control cable on bearing pot |
| q | replace |
| 7 - | Cover for gearshift mechanism |
| q | with affixed gasket |
| 8 - | 9 Nm |
| q | self-locking |
| q | for attaching the cover to the gearshift mechanism |
| q | 4 pieces |
| q | replace → Electronic Catalogue of Original Parts |
| 9 - | Selector lever control cable |
| q | do not bend or buckle |
| q | if the boot is damaged the selector lever control cable must be replaced |
| q | testing and adjusting → Chapter |
| q | removing and installing → Chapter |
| q | Do not grease drawbar eye and ball socket. |
| q | when installing in the vehicle, clamp on the gearbox side with the fixing part to the heat shield of the exhaust system |
| 10 - | 13 Nm |
| q | for holder Pos. 11 at gearbox |
| 11 - | Support |
| q | for selector lever control cable |
| 12 - | 23 Nm |
| q | for cable support to gearbox |
| q | 2 pieces |
| 13 - | Cable support |
| q | for selector lever control cable on gearbox |
