skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Replacing gasket ring for left flange shaft (Fabia II, Roomster)|Install > < Replacing gasket ring for left flange shaft (Fabia II, Roomster)

Fabia Mk2

Removing
Removing
  Note
t  Observe the general repair instructions → Chapter.
t  Do not remove both flange shafts simultaneously from the gearbox. If the differential bevel gears twist in the differential gear, it will be difficult to reinstall the fixing screw for the flange shaft.
–  Loosen the front left wheel bolts.
–  Raise vehicle.
–  Unscrew the front left wheel.
–  Remove the sound dampening system → Body Work; Rep. gr.50.
–  Turn the sterring wheel to the left up to the stop and remove the left drive shaft from the flange shaft → Chassis; Rep. gr.40.
   
–  Unscrew nuts -arrows- for left steering joint → Chassis; Rep. gr.40.
  N40-10350
–  Unscrew the nut -1- from the coupling rod -3--arrow- → Chassis; Rep. gr.40.
–  Remove coupling rod and turn anti-roll bar -2- slightly upwards.
–  Swivel out left wheel-bearing housing.
–  Swivel the left drive shaft into the wheelhouse and secure it to the suspension strut, e.g. with cord. Avoid damaging the paintwork on the drive shaft during this operation.
–  Position the catch pan under the gearbox.
  N40-10382
–  Unscrew screw for flange shaft with socket insert -T10107A- or commercially available socket insert 6 mm.
–  Take out the flange shaft.
  N39-10429
–  Pull out gasket ring for flange shaft with multi-purpose tool -MP3-419 (VW 771)- and the extractor -MP3-419/37 (VW 771/37)-.
  N39-10439

Replacing gasket ring for left flange shaft (Fabia II, Roomster)|Install > < Replacing gasket ring for left flange shaft (Fabia II, Roomster)