skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Disassembling and assembling engine > < Removing and installing V-ribbed belt

Fabia Mk2

Summary of components for vehicles with an air conditioning system
   
Summary of components for vehicles with an air conditioning system
  Note
t  Mark the rotation direction before removing the V-ribbed belt. Reversing the rotation direction of an already used belt may destroy it.
t  Pay attention to the correct position of the V-ribbed belt in the belt pulley when installing it.
t  Vehicles without an air-conditioning system do not have an air-conditioning compressor or guide pulley.
1 - 22 Nm
2 - Belt pulley
q   on the coolant pump
3 - Trim
4 - Tensioner with tensioning pulley
q   do not remove the tensioning pulley.
5 - 40 Nm
q   Component part of the guide pulley
6 - Generator
q   to facilitate positioning of the generator on the cylinder block, drive the threaded bushings of the screws slightly backwards
7 - Guide pulley
8 - Belt pulley
q   at the crankshaft
9 - 150 Nm + torque a further 180° (1/4 turn)
q   replace
q   interlock the crankshaft with fixing bolt -T10121- for loosening and tightening it up → Chapter
10 - Spacer sleeve
q   for generator
11 - 23 Nm
12 - Spacer sleeve
q   for the AC compressor
13 - Dowel sleeves for AC compressor
q   must be inserted in the cylinder block
14 - V-ribbed belt
q   Routing of the ribbed V-belt:
t  vehicles without air conditioning → Fig.
t  Vehicles with air conditioning → Fig.
q   removing and installing → Chapter

Removing
–  Mark the rotation direction of the V-ribbed belt.
   
–  Lever off the cover for the tensioning roller -A-.
–  Swing out the tensioning roller -A- with Torx key 50 -B- in the direction of travel up to the stop and remove the V-ribbed belt.
  Note
The tensioning roller can be interlocked by inserting a rig pin.
Install
  Note
t  Before fitting the V-ribbed belt make sure that all assemblies (generator, coolant pump and AC compressor) are securely mounted.
t  Check smooth operation of belt pulley, tensioning and guide pulley.
t  Pay attention to the rotation direction of the already used V-ribbed belt.
t  Inspect the V-ribbed belt:
   → BookletFabia II.
   → BookletRoomster.
–  Position the V-ribbed belt on the belt pulleys and guide pulley.
  S13-0348
–  Swing out the tensioning roller -A- with Torx key 50 -B- in the direction of travel up to the stop and lay the V-ribbed belt in place.
–  Press on the cover of the tensioning roller -A-.
–  Start engine and check belt run.
  S13-0348
V-ribbed belt run - without an air conditioning system
1 - Belt pulley - crankshaft
2 - Belt pulley - coolant pump
3 - Tensioning pulley
4 - Belt pulley - AC generator
  S13-0305
V-ribbed belt run - with an air conditioning system
1 - Belt pulley - crankshaft
2 - Belt pulley - coolant pump
3 - Tensioning pulley
4 - Belt pulley - AC generator
5 - Belt pulley - AC compressor
6 - Guide pulley
  S13-0347

Disassembling and assembling engine > < Removing and installing V-ribbed belt