Fabia Mk2
Oil filter holder and engine oil cooler - Summary of components |
1 - | Gasket |
q | replace |
2 - | 15 Nm + torque a further 90° (1/4 turn) |
q | replace |
q | first of all set up the bolt at the top left and the bottom right and then tighten all four bolts cross-wise |
3 - | Oil filter holder |
q | with a pressure control valve, which opens at an overpressure of 0.45…0.55 MPa (4.5…5.5 bar) |
4 - | Sealing ring |
q | replace |
5 - | Connection fittings, 25 Nm |
q | for oil feed line to turbocharger |
6 - | Oil feed line |
q | to exhaust gas turbocharger |
7 - | Oil pressure switch 0,07 MPa -F1-, 20 Nm |
q | Cut open gasket ring if leaking and replace |
q | check → Chapter |
8 - | Screw cap, 25 Nm |
9 - | O-ring |
q | replace |
10 - | Oil filter element |
q | when replacing, replace O-rings (Pos. 9) |
11 - | Screw plug, 10 Nm |
12 - | Gasket |
q | replace |
q | fit into the grooves on the oil cooler |
13 - | Oil cooler |
q | Check fitting position |
14 - | Gasket |
q | replace |
15 - | Screw plug, 25 Nm |