Fabia Mk2
|
1 - | Differential pressure sender -G505- |
2 - | 3 Nm |
3 - | Control line |
4 - | Clamps |
5 - | Exhaust gas temperature sender 4 -G648-, 45 Nm |
q | the thread of the new temperature sender must be coated with assembly paste |
q | grease only the thread with hot bolt paste -G 052 112 A3- for re-used temperature sender. |
6 - | Lambda probe -G39-, 50 Nm |
q | the thread of new lambda probes must be coated with assembly paste |
q | for a re-used lambda probe, only coat the thread with hot bolt paste -G 052 112 A3- |
q | the hot bolt paste -G 052 112 A3- must not come into contact with the slots of the probe body |
7 - | Heat shield |
8 - | 9 Nm |
9 - | Diesel particle filter |
q | removing and installing → Chapter |
10 - | Gasket |
q | replace |
q | Check fitting position |
11 - | Warm-type clamp, 7 Nm |
q | replace |
12 - | 25 Nm |
13 - | 25 Nm |
14 - | Support |
q | screwed onto the cylinder block |
15 - | Exhaust gas temperature sender 3 -G495-, 45 Nm |
q | the thread of the new temperature sender must be coated with assembly paste |
q | grease only the thread with hot bolt paste -G 052 112 A3- for re-used temperature sender. |
q | tighten → Chapter |
16 - | Support |
17 - | 25 Nm |
18 - | 45 Nm |
q | for pressure line |
19 - | Support |
q | for differential pressure indicator -G505- |