Fabia Mk2
|
| 1 - | Lambda probe -G39-, 50 Nm |
| q | the thread of new lambda probes must be coated with assembly paste |
| q | for a re-used lambda probe, only coat the thread with hot bolt paste -G 052 112 A3- |
| q | the hot bolt paste -G 052 112 A3- must not come into contact with the slots of the probe body |
| 2 - | Gasket |
| q | replace |
| q | Check fitting position |
| 3 - | Warm-type clamp, 7 Nm |
| q | replace |
| 4 - | Exhaust gas temperature sender 4 -G648-, 45 Nm |
| q | the thread of the new temperature sender must be coated with assembly paste |
| q | grease only the thread with hot bolt paste -G 052 112 A3- for re-used temperature sender. |
| q | tighten → Chapter |
| 5 - | Exhaust gas temperature sender 3 -G495-, 45 Nm |
| q | the thread of the new temperature sender must be coated with assembly paste |
| q | grease only the thread with hot bolt paste -G 052 112 A3- for re-used temperature sender. |
| q | tighten → Chapter |
| 6 - | Support |
| q | for differential pressure indicator -G505- |
| 7 - | Clamps |
| 8 - | Control line |
| 9 - | Differential pressure sender -G505- |
| 10 - | 4.5 Nm |
| 11 - | 25 Nm |
| 12 - | 25 Nm |
| 13 - | Support |
| q | screwed onto the cylinder block |
| 14 - | Catalytic converter with diesel particle filter |
| q | removing and installing → Chapter |
