skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Testing brake vacuum pump V192 > < Removing and installing brake servo unit

Octavia Mk1

Removing and installing brake vacuum pump V192
Removing and installing brake vacuum pump -V192-
No provision is made for repairing the brake vacuum pump -V192-. The brake vacuum pump -V192- must be replaced if a fault arises.
The fitting location of the brake vacuum pump -V192- can be found on the bottom left of the assembly carrier
Removing
   
–  Unscrew the screws -1- at the bracket for the brake vacuum pump -V192-.
–  Remove the vacuum hose -arrow- from the brake vacuum pump -V192-.
–  Take out the brake vacuum pump -V192-.
–  Unlock the plug connection and remove it from the brake vacuum pump.
  N47-0154
–  Bracket -arrow- for the brake vacuum pump -V192-.
–  Unscrew the counternut -2- from the screw -1-.
–  Release screw -4-.
–  Remove bracket.
–  Unscrew the screws -3- for further disassembly of the bracket -arrow-.
Install
Installation is carried out in the reverse order.
  N47-0155
Tightening torques:
Nut -2- to bracket20 Nm
Screws -3- to bracket8 Nm
Screw -4- to bracket20 Nm
Inner Torx screw for brake vacuum pump -V192- to bracket8 Nm

   

Testing brake vacuum pump V192 > < Removing and installing brake servo unit