skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing assembly carrier > < Removing and installing the track control arm

Octavia Mk1

Pressing out and in the bearing for the track control arm
Pressing out and in the bearing for the track control arm
Special tools and workshop equipment required
t  Pressure plate -MP 3-406-
t  Pressure plate -MP 3-407-
t  Pipe section -MP 3-414-
t  Pipe section -MP 3-429-
t  Pressure washer -MP 3-456-
t  Assembly device -MP 5-402-
t  Assembly device -MP 6-401-
t  Pressure spindle -MP 6-405-
t  Base -MP 6-407-
t  Pressure pipe -MP 6-408-
t  Workshop press, e.g. -V.A.G 1290 A-
t  acid-free lubricant, e.g. -G 294 421-
   
Press off front bearing for track control arm
  S40-0080
Press in front bearing for track control arm
–  Insert bearing into pipe section -MP 3-414-.
  Note
Use acid-free lubricant, e.g. -G 294 421-, when pressing in the bearing. Under no circumstances use grease or detergent.
  S40-0081
Fitting position of rear bearing for track control arm
One of the embossed arrows points to the impression in the track control arm, the kidney-shaped recess (-arrow A-) in the bearing points to the centre of the vehicle.
  V40-1010
Pressing out and in the rear bearing for the track control arm
Pay attention to the fitting position when pressing in → Anchor.
  S40-0082

Removing and installing assembly carrier > < Removing and installing the track control arm